MK1 02M 6speed Transmission Mounts – 4cyl

$275.00

We don’t often have a request for these but every now and then someone wants to get crazy and put an 02m in their mk1.

We keep these in stock but in low volume. If you need them immediately please make sure we do have them ready to ship before you order. These are made from 8mm laser cut steel. They are beefy mounts to support that fatty 02M trans..

  • Uses the stock size 64mm mk1 style trans mount and Square mk1 rear trans bushing.
  • For 4cyl engine placement IE..  not for a VR6
  • Axles are available here

In stock

64mm Mk1 Poly Transmission Mount Bushing

64mm mount bushings were using on the upper trans mount starting in 74 through 93, they also used the 64mm bushing on some of the motor mounts but that was early cars only.

These bushings are 65a hardness which is just tougher than the OEM HD mount bushings. It is considerably softer than the 85a poly bushings (red – energy) that will rattle your teeth out of your head.

Sold individually, mount brackets are sold separately.

Mk1 02M 4cylinder Axle Set

Custom built for us by an these axles are cut from 4041 steel, heat treated, balanced, and assembled with OE splined mk1 cv joints for easy install, and if needed you can use a stock cv joint to replace a damaged joint, no custom parts, easy to keep your mk1 on the road. (Price is for a PAIR)

  •  These Axles use OE style CV joints, Mk5 108mm inner joints with 90mm mk1 outers - aftermarket cv spline counts will not fit, if you are looking for replacement joints they must be OE spline counts..
  • These axles are being built on demand at the moment, I don't have a manufacture ready to knock out 100 units at once.. Please allow up to 4 weeks from the time of order to delivery, I will try to always have a couple sets on the shelf, but until I get a manufacture to build them the way I want, these will be built as needed.. so if it says its on backorder there isn't a set to ship immediately, you can order them and they will ship ASAP

Description

We don’t often have a request for these but every now and then someone wants to get crazy and put an 02m in their mk1.

We keep these in stock but in low volume. If you need them immediately please make sure we do have them ready to ship before you order. These are made from 8mm laser cut steel. They are beefy mounts to support that fatty 02M trans..

  • Uses the stock size 64mm mk1 style trans mount and Square mk1 rear trans bushing. (Not included)
  • For 4cyl engine placement IE..  not for a VR6
  • Axles are available here