Posted on

Mk1 Vr6 Hardware Videos and Install Tips

I made a couple hardware overviews for our MK1 Vr6 kits, and I still have a few questions that I either didn’t address in one video or a tip I forgot, I am going to add a couple more videos soon, but this may make finding the info you’re looking for a little easier, if you have questions before during or after install please feel free to email me! Sal@s-pautomotive.com

 

General install Tips:

  • Press your bushings in before you mount the brackets onto the motor or chassis
  • If you have an 02j trans the upper trans mount holes are threaded, you need to drill them out to use the hardware provided
  • Grease the inner speedo cable with a silicone grease before installing!
  • I find it easier to set the radiator in the core support before I install the motor – but not bolt it down
  • For a cleaner install on a AAA motor if you’re not using the AC/PS systems cut the bracket off just below the alternator mounting points to the block.
  • Always start all the bolts in a bracket, manifold,cover etc before tightening any of them down
  • If you are using the mk1 fuel lines, the best place to cut them I have found is just before the cross behind the steering knuckle, you can carefully hand bend them up toward the passenger strut tower and trim again to your desired length
  • Work the exhaust system from front to back, hang everything loose in the clamps and work each section into final placement front to back as well
  • If you’re using one of our harnesses the “Trigger” needs to have power in both the key positions START and RUN – this is often the problem for a no start, someone didn’t check that the wire they chose had power during the crank key cycle. A good source for this is your former coil power wire on gasoline cars, on diesels the injection pump power wire works well.

 

 

Posted on

Matts 1981 VRirocco

Matt wanted to be able to jump in his Scirocco and drive it everyday, without worrying about the failing CIS system leaving him on the side of the road.   To overhaul the 1.8 and rebuild the CIS system was a realistic option, however after looking at the cost of the rebuild he realized he was well on his way to a later model motor swap.  Even better.  Better mileage from an 02 controlled fuel system, more power, easier to find parts. Win-win!

On to the evidence!!

IMG_5176 IMG_5177

Slightly better after a washing!

IMG_5178 IMG_5179

Ready to Paint!

IMG_5184 IMG_5189

Our  MK1 VR6 motor mounts ready to go!

IMG_5181 IMG_5180IMG_5182

Motor hanging!

IMG_5201IMG_5202

Integrated Cable Boss on our mk1 02a mounts, we also offer a smooth version for our mk1 hydro kit

IMG_5211

 

Its ready to go home!

Mk1 Vr6 Scirocco conversion, stainless shift rod kit, full 2.5″ stainless exhaust, silicone coolant lines, hidden 3″ maf intake pipe, 2.25″ tucked radiator with fan and shroud.  everything you need to have a fun in your mk1!

 

Interested in installing one into your own mk1? Interested in having us install one into your mk1?

Check the kit out here !!  Contact us anytime :  info@s-pautomotive.com